Installation Guide

Part Number: RJ521353 REV B
Revision Date: 4-3-18
Installation Instructions
TWH-LED
DELIVERY: Upon receipt of fixture and accessories (packed separately), thor-
oughly inspect for any freight damage. All damage should be reported to the
delivery carrier. Compare the catalog description listed on the packing slip with
the fixture label on the inside of the housing to be sure you have received the
correct merchandise.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
5 year limited warranty
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: [phone] • Fax: [phone] • www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved.
Outlet box mounting:
1. Loosen the 2 captive screws in the front housing and remove front cover from fixture.
2. Remove electrical splice compartment cover. Keep (2) 10-24 screws for reinstallation. See Figure A.
3. Remove center knock out and feed wires through.
4. Mount fixture using dimensions shown in Figure B.
5. Make supply connections. Reinstall the (2) 10-24 screws and electrical splice component cover removed in step 2, making
sure no wires are pinched.
5A. If provided with an ALO device (inside of the front cover), adjust the dial to the required lumen level (use the ALO table as
reference), by turning it using a small flat head screwdriver.
6. Replace front cover.
7. Tighten the 2 captive screws (30-35in lbs). Do not over tighten. Over tightening will cause stripping and void all warranties.
VIEW OF BACK CASTING
6"
(15.2cm)
10"
(25.4cm)
15-3/4"
(40cm)
15-1/4"
(38.8cm)
5"
(12.7cm)
3/8" Dia.
(1.0cm)
Mounting Holes
(3)
3" to bottom
of unit
7/8" Dia. K.O.
(2.2cm)
2-1/4" (5.7cm)
Figure B
Figure A
Electrical splice
compartment
cover
8"
(20.3cm)