Installation Instructions

Installation Instructions
RSX LED
©2016 Acuity Brands Lighting, Inc.
All Rights Reserved.
Lithonia Lighting Outdoor
One Lithonia Way, Conyers, GA 30012
Phone: [phone] Fax: [phone]
www.lithonia.com
Part Number: IM-459 Rev A
Revision Date: 8/29/19
3. Loosen the set screws enough to ip the luminaire over as shown below in gure 8a, then loosen the six capve screws
on door to access the wire connecon area. Remove the rubber grommet (see gure 8b) before feeding the wires.
4. Remove the luminaire from the tenon to insert input wires through the holes of the rubber grommet, pull them into the
wire connecon area. Replace the rubber grommet back as originally assembled before wire feeding (See Figure 8b & 8c).
Page #5