Installation Instructions

RSX LED

Lithonia Lighting Outdoor

One Lithonia Way, Conyers, GA 30012

Phone: 800-279-8041 Fax: 770-918-1209

www.lithonia.com

Part Number: IM-459 Rev A

Revision Date: 8/29/19

NOTE: Luminaire can be lted up to 90 degrees above horizontal

Tools Required:

• 3/8" Socket Wrench

• 9/64" Allen wrench

• 3/8” Allen Wrench

Minimum Square Pole: 3.5” Face

Minimum Round Pole: 3.2” Diameter

1. Loosen the cover screws of the arm cover (See gure 20) and

remove the cover to gain access to the top half of the key-slot

mounng feature.

2. Idenfy which mounng bar should be used to aach the

luminaire to the pole. Refer to the RPA/SPA installaon instruc-

ons, steps 2 through 6. Note that main dierence in mounng

is that the top bolt on the AASP/AARP will be inside the wiring

area and the boom bolt will be exposed. Once the luminaire is

mounted securely to the pole, the angle of the luminaire can be

safely adjusted.

3. If the luminaire angle will be adjusted DO NOT pull

the luminaire supply wires taut – leaving slack in the input wires

will make angle adjustment easier. If the luminaire angle will not

be adjusted, skip to step 5.

4. Loosen the 7/16-14 adjustment bolt, reorient luminaire as

desired, up to 90°, and reghten adjustment bolt to 35-40 -lbs

(See Fig 21). For units with photocontrol receptacle, the xture

mounng angle must be restricted per ANSI C136.10 and it is

recommended to not install beyond 45° from horizontal.

5. Make all wiring connecons via the supplied wire leads in ac-

cordance with NEC and local codes.

6. Ensure that the arm cover gasket is sll in place and place it

back in the channel if it has come loose.

7. Place wires back into the arm cavity and, ensuring that no

wires or tethers are going to be pinched, reaached the arm

cover. Tighten the cover screws to 18-20 in-lbs.

8. Energize the luminaire to verify its operaon and proper il-

luminaon of area.

AASP/AARP INSTALLATION INSTRUCTIONS

Page #12