Installation Guide

page 3
INSTALLATION INSTRUCTIONS
FIXTURE PACKING LIST
Description Quantity
1) LED Light Fixture................................................................. 1
2) Photocell.............................................................................. 1
3) 3/4” Mounting Screws* ........................................................ 2
4) Cross Bar &Threaded Pipe* ................................................ 1
5) Decorative Nut* ................................................................... 1
6) Wirenuts* ............................................................................. 3
7) Diffuser ................................................................................ 1
*Contained in parts packs
Mounting Hardware Included
Silicone Sealant Required
REQUIRED TOOLS:
If this fi xture fails to operate properly, use the guide below to
diagnose and correct the problem.
Trouble Shooting Guide
• Verify that power is turned on at switch and breaker
• Verify that fi xture is wired properly
• Verify that line voltage is correct.
• Test if Photocontrol works properly
The photocontrol in this fi xture is designed to turn on fi xture
light at low light levels.
If light does not come on or stays on:
Test if Photocontrol works properly:
• Cover Photocell - Light should come on.
• Shine a fl ashlight into Photocell- Light should go off.
If fi xture cylcles on and off:
Light refl ecting back off any surrounding surfaces enters the
photocontol. To correct problem, reposition the fi xture or eliminate
refl ective surface.
If further technical assistance is required, contact: Technical
Support at: [phone]
This LED light provides low maintenance service with no bulbs
to change. Clean surfaces with mild soap and water. Do not use
abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
WARNING: There are no user serviceable parts inside fi xture.
2) Photocell
1. Remove fi xture components and parts pack. Check to ensure
all parts are included. Note: Account for small parts and destroy
packing material, as these may be hazardous to children.
2. Turn OFF Power at circuit breaker box!
CAUTION: Do not rely on wall switch alone to turn off power.
Note: NOT suitable for use with dimmers, motion sensors or other
remote devices.
Note: Fixture is intended for Wall mount above 4 ft (1,2m).
3. Install Cross Bar (4) to junction box using two 3/4” screws (3).
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off!
4. Ground fi xture
With the power turned off, hold the fi xture fi rmly and connect the
green ground wire from the fi xture to the bare copper ground wire
from the junction box using Wirenut (6) Note: If house wiring does
not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
5. Connect supply wires
Use Wirenuts (6) to connect the black fi xture wire to the black
power supply wire and the white fi xture wire to the white (neutral)
supply wire.
6. Tuck wires into junction box.
7. Align hole in back of LED Fixture over Threaded Pipe in
Crossbar and secure fi xture in place with Decorative Nut (5).
8. Turn on electricity at fuse or circuit breaker box and verify
success of installation. Note: Test fi xture at night or block
Photocontrol.
9. Apply silicone caulking (not included) for moisture seal.
Figure A
3) 3/4” Screws
1) LED Light Fixture
4) Cross Bar &
Threaded Pipe
5) Decorative Nut
6) Wirenut
7) Diffuser