Installation Guide

I
N
ST
A
LL
A
TION
INSTRU
C
T
I
ONS
LITHONIA TRACK ACCESSORY
DOWNLIGHTING & TRACK SYSTEMS
ONE LITHONIA WAY, CONYERS, GEORGIA 30012, TELEPHONE [phone], FAX [phone]
www.lithonia.com IN CANADA: 1100 50TH AVE., LACHINE, QUEBEC H8T 2V3
FEATURES:
1. White finish with black cover included for use with white or black track sections.
2. Connects a track section to a junction box at the end of the track to supply power.
3. All mounting hardware is included.
4. For use with Lithonia Lighting white or black track system only.60Hz 120V
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at
or visit Please reference SKU UPC
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):
Ladder
Safety
Goggles
Gloves
Flathead
Screwdriver
Phillips
Screwdriver
Electrical
Tape
Wire
Cutters
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
x1 Black canopy
x1 Screws
INSTALLATION INSTRUCTIONS:
1. Before installing, disconnect power by turning off circuit breaker or removing fuse from fuse box.
2. IMPORTANT: Prior to insertion of the live end connector, determine the ground side of track (has indented groove on face
and two internal copper bars) and match it with the live end connector tabs (side of connector with two metal tabs). The unit
can only be connected if the grounds are aligned.
3. Position cover plate over ceiling junction box. Choose slots on cover plate which align with junction box screws and mark cover
accordingly. Pierce cover at location of marks. Feed supply wires through cover and attach cover to box with screws provided on
the box.
4. Loosen set screw on dead end cap at the appropriate end of the track and remove. Loosen set screw on connector.
5. Aligning the ground sides of track and connector, push connector into open end of track. Tighten set screws.
6. Place track connector assembly against ceiling aligning the center of the connector to center of the junction box. Mark track holes
and proceed with installation as described in track installation instructions.
7. Remove the connector cover. Make electrical connections. Attach the white (neutral) wire from the outlet box to the silver screw
from the live end connector; Attach the Black (Hot) wire from the outlet box to the brass screw from the live end connector; Attach
the Green or bare copper (ground) wire to the green screw from the live end connector. Replace the connector cover.
8. Push the cover into track. Tighten set screws.