Installation & Assembly

INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
AND DELIVER TO OWNER AFTER INSTALLATION
SURFACE MOUNT EDGE-LIT LED EXIT SIGN
Standard & New York Approved Model
(Emergency, non-Emergency and X2 Dual Circuit operations)
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS: When using electrical equipment, basic safety
precautions should always be followed, including the following:
1. Consult local building code for approved wiring and installation.
2. Disconnect AC power before servicing and installation.
3. Do not mount near gas or electric heaters.
4. UL Damp location listed standard. (0°C- 50°C)
5. Do not use this equipment for anything other than its intended use.
6. The use of accessory equipment not recommended by the manufacturer will void
product listing and warranty and may cause an unsafe condition.
7. Any service on this equipment should be performed by qualifi ed personnel only.
8. Equipment should be mounted in locations and at heights where it will not be subject
to tampering by unauthorized personnel.
9. Use caution when servicing batteries (EL operation only).
10. Cap unused wires with enclosed wire nuts or other approved method.
11. Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.
INSTALLATION INSTRUCTIONS
Choose mounting confi guration (end, top or back mount). Plug remaining holes with the appropriate color plugs.
1. Secure canopy bracket to ceiling or wall.
2. Open the housing cover.
3. Secure housing and canopy with screws (see mounting confi guration).
4. Feed the AC input leads through the housing and canopy’s center hole. Reference wiring dia-
grams on back and connect AC input leads to AC power supply leads.
5. Secure canopy into canopy bracket with 1½” long #8-32 screws.
6. EL Operation: Insert battery terminal wire into two-pin male connector.
7. Connect battery only after continuous AC power can be provided to the unit.
8. Snap housing cover into place.
9. Apply Chevron directional indicators as required. Remove application templates when fi nished.
INSTALLATION (END MOUNT):
1. Secure canopy to end plate of fi xture using mounting holes C and E with two (2) ¾” # 10-24
screws (included).
2. Run connection wires through large hole between mounting holes C and D.
3. Make electrical connections and mount canopy to junction box (or spider plate if required) using
the two recessed mounting holes and two (2) 1½” #8-32 screws (included).
INSTALLATION (TOP MOUNT):
4. Secure canopy to top of fi xture using mounting hole A with ¾” #8-32 screw and hex nut, and ½”
center hole (between mounting holes B and C) with threaded nipple and hex nuts (included).
5. Run connection wires through threaded nipple.
6. Make electrical connections and mount canopy to junction box (or spider plate if required) using
the two recessed mounting holes and two (2) 1½” #8-32 screws (included).
END MOUNT
BACK MOUNT
TOP MOUNT