Installation Guide
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. CAUTION- To prevent electrical shock, do not mate unit connector until installation is complete and A.C.
power is supplied to the unit.
2. CAUTION
-
necting the unit connector.
3. CAUTION-This is a sealed unit. Components are not replaceable. Replace the entire unit when necessary.
4. CAUTION
opening.
6. The LEM emergency driver and A.C. driver must be on the same branch circuit.
7. Do not mount near gas or electric heaters.
8. The LEM emergency driver should be mounted in locations and at heights where it will not readily be subject-
9. The LEM emergency driver will supply 20-50VDC
10. This product is suitable for use in damp locations where the ambient temperature is 0ºC minimum, +50ºC
11. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void
12. Do not use this equipment for other than intended use.
13. Install in accordance with the National Electrical Code and local regulations.
14. The emergency LED driver is for use with grounded, UL listed LED luminaire, shall be enclosed by the LED
luminaire and bonded to the grounding of LED luminaire.
SAVE THESE INSTRUCTIONS
Emergency LED Drivers
Models LEM04 and LEM08
INSTRUCTION MANUAL
EMERGENCY LED DRIVER FOR USE WITH
LED LUMINAIRES IDENTIFIED IN THE
MANUFACTURER’S
INSTALLATION INSTRUCTIONS
E484840
ONE LITHONIA WAY, CONYERS, GEORGIA 30012, TELEPHONE 800-334-8694