Cut Sheet

LDN6 SWITCHABLE
6" OPEN
New Construction Downlight
ORDERING INFORMATION
Example: LDN6 ALO2 SWW1 LO6AR LSS MVOLT UGZ
DOWNLIGHTING LDN6 SWW
Lead times will vary depending on options selected. Consult with your sales representative.
Catalog
Number
Notes
Type
D
I
M
M
A
B
L
E
FEATURES & SPECIFICATIONS
INTENDED USE — Typical applications include corridors, lobbies, conference rooms and private offices.
CONSTRUCTION — Galvanized steel mounting/plaster frame; galvanized steel junction box with
bottom-hinged access covers and spring latches. Reflectors are retained by torsion springs. Vertically
adjustable mounting brackets with commercial bar hangers provide 3-3/4" total adjustment. Two com-
bination ½"-3/4" and four ½" knockouts for straight-through conduit runs. Capacity: 8 (4 in, 4 out). No.
12 AWG conductors, rated for 90°C.
Accommodates 12"-24" joist spacing.
Passive cooling thermal management for 25°C standard. Light engine and drivers are accessible from
above or below ceiling.
Ceiling thickness range 1/2" to 1-1/2".
OPTICS — 55° cuto
1.0 S/MH standard (wallwash reflector available)
80CRI standard (90CRI optional)
ELECTRICAL — Adjustable lumen output with three module options.
MVOLT 120/277V 50/60Hz driver (0-10V & 120V Phase Dimming to 10% min dimming level). DALI driver
dimming to 1% also available
100LPW typical
FCC CFR Title 47 Part 15 Class A for 277V. FCC CFR Title 47 Part 15 Class B for 120V.
L80 @ 60,000 hours
3 SDCM
LISTINGS — Certified to US and Canadian safety standards. Title 24 compliant (90CRI, up to 1000lm)
Wet location, covered ceiling. Wallwash suitable for damp locations only. Some configurations are Energy
Star certified, please visit www.energystar.gov for specific products.
WARRANTY — 5-year limited warranty. This is the only warranty provided and no other statements
in this specification sheet create any warranty of any kind. All other express and implied warranties are
disclaimed. Complete warranty terms located at:
www.acuitybrands.com/support/warranty/terms-and-conditions
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specifications subject to change without notice.
CAN BE USED TO
COMPLY WITH 2019
JA8 HIGH EFFICACY LED LIGHT
SOURCE REQUIREMENTS
LDN6
Series Lumens Color temperature Aperture/Trim Color Reflector Flange Finish Distribution Voltage
LDN6 6" Round ALO1 500/750/1000lm
ALO2 1000/1500/2000lm
ALO3 2000/2500/3000lm
AL04 4000/4500/5000lm
Fixed Lumen Output
05LM 500lm
07LM 750lm
10LM 1000lm
15LM 1500lm
20LM 2000lm
25LM 2500lm
30LM 3000lm
40LM 4000lm
45LM 4500lm
50LM 5000lm
SWW1 3000K-3500K-
4000K-5000K
Fixed CCT
30K 3000K
35K 3500K
40K 4000K
50K 5000K
LO6 Downlight
LW6 Wallwash
AR Clear
WR White
painted
BR Black
painted
(blank) Self-flange
TRW White
TRBL Black
LSS Semi-specular
LD Matte diffused
LS Specular
(blank) Medium
Wide
(1.0s/mh)
WD Wide
(1.2s/mh)
MVOLT 120V - 277V
347 347V
step-down
transformer
supplied
Driver Options nLight Options
UGZ Universal dimming to 10% 0-10V; line
voltage dimming (120V)
UGZ1 Universal dimming to 1% 0-10V; line
voltage dimming (120V)
DALI DALI dimming to 1%
D10 Minimum dimming 10% driver for use
with JOT D1 Minimum dimming 1%
driver for use with JOT
D1 Minimum dimming 1% driver for use
with JOT
90CRI High CRI (90+)
AT Airtight (IP55)
CP Chicago Plenum
EL Batterypack (10W constant power) Non-T20 Compliant,
integral test switch
ELR Batterypack (10W constant power) Non-T20 Compliant
remote test switch
E10WCP Batterypack (10W constant power) T20 Compliant,
integral test switch
E10WCPR Batterypack (10W constant power) T20 Compliant, remote
test switch
JOT Wireless room control with “Just One Touch” pairing
NPS80EZ nLight® network power/relay pack with 0-10V dimming
NPS80EZER nLight® network power/relay pack with 0-10V dimming;
ER controls fixtures on emergency circuit.
NLTAIR2 nLight® Air enabled
NLTAIRER2 nLight® AIR Dimming Pack Wireless Controls. Controls
fixtures on emergency circuit
NLTAIREM2 nLight® AIR Dimming Pack Wireless Controls. UL924
Emergency Operation, via power interrupt detection.
ETS Iota Emergency Transfer System

Summary of content (5 pages)