Installation Guide

6" LED Housing
L7XLED T24
LED
IC/Non-IC
New Construction
FEATURES & SPECIFICATIONS
INTENDED USE
Recessed housing rated IC or Non-IC. For new construction only.
Approved for all ceiling and wiring types.
Approved for direct burial in insulation.
CONSTRUCTION
Air-tight standard. Tested to meet current energy codes.
Aluminum foam-gasketed housing with galvanized steel pan.
Galvanized bar hangers span up to 24” o.c. and feature built in nailer and integral T-bar clips. Two locking
screws hold fixture in position.
Galvanized steel junction box with four built-in Romex clamps; five ½” and two ¾” nominal knockouts with
slots for pryout. Rated for through branch wiring.
Maximum 4 (2 in, 2 out) No 12 AWG conductors. Rated for 90° C.
Ground wire provided.
Removable J-box doors for easy access.
Trim retention (TOR): Two side-mounted torsion springs on the trim and 2 receiving brackets in the can
ensure a consistently tight fit with the ceiling.
ELECTRICAL
Quick disconnect provided for power connection to the LED modules.
Paint overspray masked by disposable disconnect plug.
Housing and LED module combination is IC rated and thermally protected.
120 volts only.
INSTALLATION
Air-tight housing suitable for air-tight installations. Refer to energy codes for proper installation.
2 x 8 wood joist or T-bar installation.
Expandable bar hangers allow for off center mounting in wood joist or T-bar ceilings.
Length of 25¼” maximum 13¼” minimum or cut to fit 9” on center joist construction.
Vertical adjustment of housing allows for flush mounting with ceiling face.
Suitable to ceilings up to 1-1/2" thick.
LISTINGS
UL Listed to US and Canadian safety standards.
Wet location listed, Title 24 compliant.
WARRANTY — 1-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Note: Actual performance may differ as a result of end-user environment and application.
Specifications subject to change without notice.
Specifications
Height: 6-7/8 (17.5)
Length: 15 (38.1)
Width: 13-7/8 (35.2)
Ceiling cutout: 7 (17.8)
13-3/8”
(33.9)
14-1/8”
(35.9)
7-1/2”
(19.1)
6-7/8”
(17.5)
6-7/8”
(17.5)
7-7/8”
(20.00)
13-7/8"
(35.2)
7-7/8"
(20.0)
6-7/8"
(17.5)
15"
(38.1)
6-7/8"
(17.5)
6-7/8"
(17.5)
13-7/8
(35.2)
7-7/8
(20.0)
6-7/8
(17.5)
15
(38.1)
277V
Transformer
option 277V step down transformer
DOWNLIGHTING L7XLEDT24
Catalog
Number
Notes
Type
Accessories: Order as separate catalog number.
ATK6 R6 6” Air-tight trim kit
HS6875 6-7/8" hole saw
L7XLED T24
Series Options Packaging
L7XLED T24 SDT 277V Non-IC 277V step-down transformer (277V to 120V).
Only available with REALITY LED Module (REAL6)
R6 Resale pack of six
U Unit
ORDERING INFORMATION
For shortest lead times, configure products using bolded options.
Example: L7XLED T24
All dimensions are inches (centimeters) unless otherwise specified.