Installation Guide


Lithonia Lighting
INDUSTRIAL VALUE STREAM
One Lithonia Way, Conyers, GA 30012
Phone: [phone] Fax: [phone]
www.lithonia.com
Part Number: U219858
Revision Date:
2.2.1 Surface Mount Bracket (JEBLSMB) - The
optional Surface Mount Bracket is designed to attach to
JEBL fixture housing with supplied mounting screws.
2.2.2 Remove hole plugs from bracket mounting surface.
(See Figure 2)
2.2.3 Position Mounting Bracket onto fixture housing
aligning mounting holes with holes on housing. Install
provided mounting screws, lock washers and washers to
attach Mounting Bracket to fixture housing. (See Figure
2).
2.2.4 Install Surface Mount Bracket to mounting surface
with suitable hardware (not provided) to support full
weight (14 lbs) of luminaire.
Figure 2
3.0 Supply Wire connections Make all supply wire
connections in accordance with local electrical codes.
3.1.1 Connect the LED high bay wiring to line wire,
black‐to‐black, white‐to‐white and green‐to‐green.
Purple and gray wires are for 0‐10V dimming and shall
be capped with a wire nut (not provided) for each wire
when not used. Use only UL listed wiring connectors
90C (or greater) and UL listed wiring (90C or greater).
4.0 Care and Maintenance
Wipe off exterior dirt and debris using a soft clean cloth.
Do not use abrasive cleaners on optical surfaces as this
may result in loss of optical efficiency.
Limited Warranty and Limitation of Liability
5-year limited warranty. Complete warranty terms
located at:
www.acuitybrands.com/CustomerResources/Terms_and
_Conditions.aspx.
Page 4 of 4