Technical Specifications

ManualsBrandsLithonia Lighting ManualsCommercial Lights2' LED High Bay Light

Page 5 of 5

Compatible RELOC® Cables for Industrial Luminaires (shipped and ordered separately)

OCS OCU

DC PT

IBH LED High Bay

Series Wiring instructions

RRL RELOC®-ready luminaire A Hot conductor wired to position #1 (phase A) AE Hot conductor wired to position #1 (phase A), hot conductor #2 wired to posi-

tion #2 (phase B)

B Hot conductor wired to position #2 (phase B) ABE Hot conductor wired to position #1 (phase A), hot conductor #2 wired to posi-

tion #2 (phase B), inverter conductor wired to position #3 (phase C)

1,2

C Hot conductor wired to position #3 (phase C)

C12S Hot conductor in position #1 (phase A), low voltage conductor #1 in position

#2,low voltage conductor #2 in position #3

1,3

AB Outboard hot conductor wired to position #1 (phase A), inboard hot

conductor wired to position #2 (phase B)

ORDERING INFORMATION

Lead times will vary depending on options selected. Consult with your sales representative.

Example: RRLA

Notes

1 C, ABE, and C12S options are not used with Quick-Flex QFC,

QSFC, QPT, and QD.

2 AE and ABE commercial xtures should disconnect the TSPL be-

fore unplugging the RRL so it does not go into discharge mode.

3 C12S option is used with the OnePass OD and 820 SSC, PT, and

DC for 0-10V/DALI applications.

RRL  RELOC®-Ready Luminaire

• RRL connectors can be used with Quick-Flex®, System 820 and OnePass® systems.

• Load side of connector factory installed to luminaire.

• 4-pole mating connector with push-in terminations allows for simple installation.

• Touch-safe design on both halves meets UL/CSA requirement.

• Wiping contact design allows safe disconnect under load.

IBH