Manualshelf

Installation Sheet

ManualsBrandsLithonia Lighting ManualsCommercial LightingIBG 150-Watt Matte White Integrated LED Contractor Select High Bay Light
12345678
U02301 Rev. B
Page 7 of 8
LED IMPORTANT SAFETY INSTRUCTIONS
NPP16D and Access Plate
During Shipping
Section G: Installation – External Occupancy Sensor
1) External Occupancy sensor will be pre-wired to the fixture.
2) Install external occupancy sensor to fixture by snapping into end cap as shown in the fixture below.
3) Rotate/Align the sensor head such that the sensor lens is parallel to the floor.
4) Install fixture based on specified mounting instructions.
Section H: Installation – NPP16D
1) NPP16D will be prewired to the fixture and attached to the access plate. The access plate will NOT be attached to the fixture.
2) Attach access plate to center channel using screw provided as shown below.
3) Install fixture based on specified mounting instructions.
Section I: Wiring – Emergency (BGTD, PSDC, PS1050, PS10250, PS30250)
1) Install fixture based on specified mounting instructions.
2) Input Wires will be located outside of the access plate. Access plate is not removeable. Connect unswitching power to fixture
wires labeled unswitched. Connect unswitched power to white, black, and green wires. Supply wire must meet applicable electrical
codes and be rated for a minimum of 90⁰C. Purple and gray leads are 0-10V (low voltage) dimming leads.
3) If using the PS1050 or PS10250, remove the top cover using the two quarter-turn fastners. Connector the white indictor light
connector to battery. If using the PS30250, two wires with connectors will be located outside of the access plate. Connect wires and
push back inside the luminaire as shown in the image below.
4) If using the PS1050 or PS10250, press the indicator light for testing. If using the PS30250, there will be a separate toggle switch
located on the outside of the fixture for testing.
Wires with connectors will be
located outside of fixture
Access Plate Screw
NPP16D and Access Plate
After Installation
PS30250 Toggle Switch
Indicator Light
Top Cover
Fixture Cat. No. Max mounting height (ft)
IBG 8000LM SEF AFL WD PS1050 20
IBG 12000LM SEF AFL WD PS10250 15
IBG 12000LM SEF AFL WD PS30250 26
IBG 15000LM SEF AFL WD PS10250 15
IBG 15000LM SEF AFL WD PS30250 26
IBG 18000LM SEF AFL WD PS10250 18
IBG 18000LM SEF AFL WD PS30250 22
IBG 24000LM SEF AFL WD PS10250 18
IBG 24000LM SEF AFL WD PS30250 21
IBGN 30000LM SEF AFL WD PS10250 15
IBGN 30000LM SEF AFL WD PS30250 26
Emergency Maximum Mounting Heights