Manualshelf

Installation Sheet

ManualsBrandsLithonia Lighting ManualsCommercial LightingIBG 150-Watt Matte White Integrated LED Contractor Select High Bay Light
12345678
U02301 Rev. B
Page 5 of 8
LED IMPORTANT SAFETY INSTRUCTIONS
SECTION B: REQUIRED HANDLING LOCATIONS
When handling the fixture during unpacking and installation do NOT use LED Modules for carrying/support. DO use the center
channel and end caps for carrying/support
Section C: PRE-INSTALLATION FOR ALL MOUNTING
1) Ensure power is OFF.
2) Inspect the mounting location for damage before installing new IBG Luminaire. Ensure mounting structure is properly sized to
support the weight of the fixture.
3) BPK and PS30250 are not available with THUN (Surface) or PMP (Pendant) mounting.
4) Remove luminaire from packing and inspect for any damages. If the fixture is damaged do not use; call your local representative
for assistance.
5) If a protective wrapping is included, do not remove until the final building/inspection stage. Do not use this luminaire as a work
light during construction. Do not touch the LEDs.
6) After installation ensure no wires are pinches or caught outside the electrical channel.
SECTION D: INSTALLATION - SUSPENDED FIXTURE
1) If using the V-hanger and chain, feed hanger through chain link.
2) If using the HBBS V-Hanger (supplied with HBBS36 and HBBSACVH), hook the hanger through holes in end cap shown below and
crimp closed. If using aircraft cable and hook, use the same holes to suspend the fixture. If using the HC V-Hanger (supplied with
HC36 and ZACVH), hook the hanger through holes in the electrical channel shown below. WARNING: For GYM applications additional
safety cables are needed.
Required Mounting Holes for
HBBS V-hanger, Hooks, Etc.
Access
Plate
Screw
Required Mounting Holes for
HC V-hanger (supplied with
HC36 and ZACVH)