Installation Instructions

Page 4 of 9
U4118 Rev A
LED IMPORTANT SAFETY INSTRUCTIONS
BPK OPTION (Access Plate not removable) WGX OPTION
V-HANGER ACCESSORY THUN ACCESSORY PMP ACCESSORY
SECTION C: PRE-INSTALLATION FOR ALL MOUNTING
1) Ensure power is OFF.
2) Disconnect all power to the existing luminaire and remove the existing luminaire from the ceiling. Inspect the existing mounting
location for damage before installing the new IBE LED high bay in this location. Ensure mounting structure is properly sized to
support the weight of the fixture.
3) BPK is not available with THUN (Surface) or PMP (Pendant) mounting.
4) Remove the new IBE LED from packaging and inspect for any damages. Handle new LED fixture with care. If damaged do not
use; call your local rep for replacement.
5) If LED fixture does not have lens option, do not touch the LEDs during installation process. Leave the protective liner on the
fixture until final stage of installation. Remove the protective plastic around the LED fixture before turning them ON.
6) After installation ensure no wires are pinched or caught outside the electrical channel.