Installation Guide

page 4
1. MOTION SENSOR SETTINGS
If you like to test your light during the daytime
• Set MODE dial to the TEST position to disable the photocell
and allow light to come on during daylight hours.
• Walk across your motion detection zone (40ft/180degree).
Note: Walk in a zigzag direction. Walking up to the motion
detector in a straight line may keep you in between detection
regions, and your light will not come on.
• If you nd motion detection is to sensitive use MOTION dial
to reduce sensitivity.
Note: Factory setting is at highest sensitivity. The sensitivity can
be adjusted to increase or decrease detection if desired. Adjust
the sensitivity as needed. If sensitivity is set too high it may cause
false triggering.
FIXTURE OPERATION
2. TIME SETTING
Once Motion detection is conrmed, set the time you want the
light to stay on after motion stops.
• Set MODE dial to 1M (minute) or 5M (minutes)
CAN THE LIGHTS STILL BE TURNED
ON/OFF WITH A LIGHT SWITCH?
At night Lights can be turned on or o󰀨 manually with a wall switch
or circuit breaker in the Manual Override Mode.
MANUAL OVERRIDE
NOTE: MODE dial must be set at 1M or 5M to use manual
override
To disable the motion sensor and keep the light continuously on
for the night, ip the wall switch o󰀨 for 5 seconds and then back
on.
To reset to Security mode, ip the switch o󰀨 again for 5 seconds
and then back on.
If you leave the light on all night it will automatically turn o󰀨 at
dawn and reset to Security mode.
NOTE: If you get confused while switching modes, turn the power
at the breaker or wall switch o󰀨 for one minute, then back on. After
the calibration time, the control will be in the Security mode.
5 Seconds OFF then...
...back on
SETTING THE MOTION SENSOR
NOTE: During daylight all lights are o󰀨. Use the daylight sensor
dial to adjust light sensor sensitivity if desired.