Installation Guide

Page 12 of 15
UT459804 Rev. B
EPANL/SPANL LED IMPORTANT SAFETY INSTRUCTIONS
RES7 Installation:
1. Remove the RES7 sensor optic from the RES7 plastic housing on the back side of the fixture (see Figure 15).
2. Remove the label on the diffuser that protected the sensor during shipping (see Figure 16).
3. Align the RES7 sensor optic with sensor (show in Figure 17) by aligning the key on the senor optic to the mating hole
on the sensor.
4. For ease of installation, place one hand on the backside of the RES7 plastic housing when pressing the cap into place
to prevent the optical components from deflecting and allowing cap to fully snap into place
5. If the RES7 sensor isn’t aligned or concentric with the optical components, you can loosen the 2 screws holding the
RES7 plastic housing and adjust the position of the sensor/housing to correct alignment.
6. Refer to Figure 18 for what a fully seated RES7 optic looks like. Note: there should not be any kind of gap and the
cap should sit fully flush with the diffuser.
Figure 15: RES7 sensor during shipping
RES7 sensor
optic
Loosen screws if RES7 sensor misaligned