Installation Guide

INSTALLATION INSTRUCTIONS
NOTE: This unit should be mounted ONLY through a pair of the preformed keyholes onto a 4” “OCTAGON” junction box, or
through a pair of the keyhole knockouts onto a 4” SQUARE junction box.
Feed the fi xture leads through the mounting plate and
make connections to AC power supply.
Use only Flexible Conduit with this
unit. Must be used with 4” j-box.
Dress the wires into the junction box. Secure the mounting
plate onto the junction box with a minimum of two screws.
NOTE: To ensure proper engagement of the snaps in the
mounting plate to the housing, DO NOT OVERTIGHTEN
SCREWS.
With AC power turned off, connect battery connector
leads.
CAUTION: Continuous AC power must be available
at time of installation as damage to the battery will occur
if the battery is connected to the charger board for more
than 3 days.
Align the holes on the bottom of the housing with the circular
snaps at the bottom of the mounting plate and push the
housing directly onto the mounting plate. (NOTE: Make
sure red battery wires are securely inside bat-
tery compartment prior to mounting housing
onto mounting plate.)
The two at the bottom, as well as the two hidden snaps at
the top should make an audible snap when fully engaged.
Apply continuous AC power and check that the test switch is
illuminated red, indicating proper function.