Instructions / Assembly

Part Number: RJ521391 Rev B
Revision Date: 9/22/15
Installation Instructions
DSXF LED
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly inspect for any freight damage. All damage should be re-
ported to the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the inside of the housing to
be sure you have received the correct merchandise.
5 year limited warranty
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: [phone] • Fax: [phone] • www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved.
Prior to Installation--Read carefully before installing light fixtures. If you do not understand these instructions, please contact your local Litho-
nia Lighting distributor before installing.
NOTE: Horizontal mounting of a fixture with the photocontrol receptacle option (PER)-- Section C136.10 ANSI, 4.5.2--The seat of
the receptacle shall be mounted as close to horizontal as possible. If it deviates more than 45° from horizontal, the integrity of the
seal may be affected when a control device is installed.
Tools Required: 9/64” and 3/16” hex key. 1/4" and 5/16” hex socket, regular screwdriver
1. Mounting
Threaded Knuckle Mount (THK): DSXF1 and DSXF2 Knuckle (1/2" NPS threaded nipple ) or DSXF3 (3/4" NPT threaded nipple) mount di-
rectly to compatible NPTF apparatus. Secure the knuckle to desired mounting apparatus by tightening the locknut (not included). To adjust
the tilt angle of the xture, loosen the 3/16” hex key screw. Adjust as necessary and retighten. Supply leads exit the knuckle mount to make
connections in wiring compartment (not provided).
DSXF1 (1/2" knuckle) DSXF2 (1/2" knuckle) DSXF3 (3/4" knuckle)
Yoke Mount (YK): (DSXF2 and DSXF3 only)
Mount the yoke to the desired bracketry by the center hole using a 3/4” bolt, lock washer, and nut (not provided). 1/2” inch bolts can be
used in the two outer holes if needed. Tighten to 30 ft.-lbs. To adjust the tilt angle of the xture, loosen the hex socket screw on each side
of the yoke. While holding weight of xture, remove hexhead set screw, adjust as necessary and reinstall in appropriate matching hole. If a
non-standard angle is desired, adjust to angle and center punch inside yoke bracket and drill a .147in(#26) hole. Reinsert hexhead set screw.
Make the supply connections to the 16-3 cord supplied.
0.18"
thickness
0.75"
0.56"
(2 plcs)
4.96"
2.50"
1.25"
2.00"
2.50"
0.63"
0.51"
(2 plcs)
0.13"
thickness
2.25"
1.25"
4.76"
DSXF2 YOKE
Yoke Mounting Plate Template
Note: This drawing is NOT to
scale and should be used for
dimensional purpose only.
DSXF3 YOKE
DSXF3 with yoke DSXF2 with yoke