Installation Guide

Page 8 of 8
912-00235-001 Rev. B
LED IMPORTANT SAFETY INSTRUCTIONS
DIMMING
All fixtures: Dimmable
Switchable fixtures:
Maximum light level for switchable luminaires is controlled by the lumen setting on the switch. These products are
capable of being dimmed down to 10% when used with 0-10V dimming controls. The fixture with the lowest switch
setting on a circuit sets the maximum output for all other switchable fixtures on that same dimming circuit.
Switching luminaires are optimized for use with “sinking” dimming controls (most common in residential and
commercial applications). If utilizing switchable luminaires in combination with “sourcing” dimming controls (most
common in theatre applications), please ensure that no more than 5 dimming devices totaling more than 10mA source
current (typical device is under 2mA) are used on a single dimming circuit.
Warranty terms are located at the link below:
http://www.acuitybrands.com/resources/terms-and-conditions
For Technical Support:
Email [e-mail] or
Phone [phone]-SERV (7378)