Installation Guide

Page 8 of 14
U351 Rev. J 03/10/2020
LED IMPORTANT SAFETY INSTRUCTIONS
SECTION E: INSTALLATION – CLX HANGER MOUNT (THCLX)
1) Attach CLX brackets to structure. If mounting to a T-Grid snap Mounting bracket into T-Grid as shown below. Two CLX brackets
MUST be used for standalone fixtures. If mounting in a continuous row one bracket per fixture with one additional bracket per row
must be used at a minimum. Two brackets per fixture is highly recommended.
2) Snap Fixture into the THCLX mounting bracket. Ensure fixture is fully engaged into the THCLX bracket, as shown below.
3) Follow steps 2-9 from the suspended mount instructions
4) Tighten THUN brackets around center channel as shown below. Tighten bolts to 13 in/lbs.
Installing THCLX to T-GRID Installing THCLX to fixture
THCLX
DO NOT REMOVE OR TIGHTEN
BOLT BEFORE INSTALLING FIXTURE
THCLX
DRIVER
CHANNEL
T-grid
Ensure mounting
bracket is fully
engaged with the
driver channel
USE CAUTION WHEN
WORKING NEAR
EXPOSED LEDS
Damage to LEDS during installation will not be
covered under warranty
Rotate THCLX
bracket to lock
onto T-Grid