Installation Guide

Page 6 of 14
U351 Rev. J 03/10/2020
LED IMPORTANT SAFETY INSTRUCTIONS
SECTION D: INSTALLATION - SUSPENDED FIXTURE
For V-hanger
1) Feed V-hanger into holes on the Driver channel.
2) Ensure supply wire is not active. If using a continuous row mount skip to steps 5-9.
3) Remove access plate screw as shown below. Input wires will be attached to the access plate. Remove the necessary knockout(s)
and connect input wires black to black, white to white and green to green. Use only UL listed connectors rated 75C or greater.
Purple and Gray wires are low voltage dimming leads. If ordering with OUTEND option ensure end cap hole and wires are enclosed
with a UL approved barrier (cordset, conduit, etc).
4) Push wires into Driver channel and reattach the access plate.
For Aircraft Cable
1) Attach bracket to ceiling. Feed aircraft cable through the small threaded pipe. Insert threaded rod into small threaded pipe. Place
canopy over bracket and screw the threaded pipe/rod assembly into bracket holding the canopy in place.
2)Open fixture by removing LED Channel and attach large threaded assembly to fixture through 0.3” dia hole using nut provided.
Close fixture and feed aircraft cable through large threaded assembly. Requires two per fixture, see following images. Refer to
Section H: Servicing on Page 10 for detailed opening instructions.
3) Ensure supply wire is not active. If using a continuous row mount skip to steps 5-9.
4) Remove access plate screw as shown below. Input wires will be attached to the access plate. Remove the necessary knockout(s)
and connect input wires black to black, white to white and green to green. Use only UL listed connectors rated 75C or greater.
Purple and Gray wires are low voltage dimming leads. If ordering with OUTEND option ensure end cap hole and wires are enclosed
with a UL approved barrier (cordset, conduit, etc).
5) Push wires into Driver channel and reattach the access plate.
Access Plate Screw
V-Hanger
V-Hanger Holes
Housing End Cap
Screw