Installation Guide

Page 11 of 14
U351 Rev. J 03/10/2020
LED IMPORTANT SAFETY INSTRUCTIONS
5) To access electrical components, remove the six screws shown below.
6) LED Channel MUST hang from driver channel during servicing as shown below.
7) If replacing drivers, ensure power to the fixture is off
8) Tag leads before disconnecting
9) Disconnect all leads from old driver.
10) Unscrew driver using two screws. Attach new driver to channel using two screws.
11) Connect leads to corresponding driver ports
12) Close LED channel and secure using six screws.
USE CAUTION WHEN
WORKING NEAR
EXPOSED LEDS
Damage to LEDS during installation will not be
covered under warranty