Installation Guide

Page 10 of 14
U351 Rev. J 03/10/2020
LED IMPORTANT SAFETY INSTRUCTIONS
SECTION H: SERVICING
1) Clean fixture as needed. Double check all mounting hardware.
2) After installation, wear protective gloves if the lenses need to be removed
3) The lens snaps into the LED channel. To remove lens, carefully squeeze lens together to disengage from LED channel.
4) To replace the lens snap into LED Channel as shown in the image below.
FDL/RDL detachment
WDL DETACHMENT/REATTACHMENT
LED CHANNEL
Lens
Squeeze together to disengage Lens from LED Channel
PRESS AGAINST LENS
WALL TO DISENGAGE
PRESS TOWARD THE
FIXTURE WHILE
PRESSING AGAINST
THE SIDE WALL TO
REENGAGE.
USE CAUTION WHEN
WORKING NEAR
EXPOSED LEDS
Damage to LEDS during installation will not be
covered under warranty