Installation Guide

IMPORTANT SAFETY INSTRUCTIONS
This fixture must be installed in accordance with local, federal codes and the NEC.
1. Read all instructions completely before beginning. Keep these instructions in safe place for future reference.
2. To reduce risk of fire and over-heating, make sure all connections are tight.
3. Turn o the electrical power before proceeding.
DROP CEILING INSTALLATION INSTRUCTIONS
FOR INDY S2X2PP, S2X2PZ, S1X4B, S2X2B,
S2X4B, S2X2L AND S2X4L SERIES
CAUTION: Risk of Electric Shock
Do not install insulation within 76mm (3 in) of any part of the luminaire.
!
ALL INDY 1X4, 2X2 and 2X4 LED fixtures are for Non-insulated ceiling applications using 1' x 4',
2' x 2' & 2' x 4' T-Bar grid drop ceilings. Designed for use in 120V~277V, 347V, 60/50Hz protected
circuit (fuse box, circuit breakers) and 90° C rated supply wire.
NOTE: FOR DRYWALL OR 9/16" CEILING APPLICATIONS, DRYWALL MOUNTING FRAME AND
9/16" FIXTURE CLIPS ARE AVAILABLE. CONSULT FACTORY FOR DETAILS.
Step 1
Remove knock out plate.
Step 2
Remove the preferred knock out.
Step 3
Insert connector. Wire to fixture appropriately based on
dimming requirements. See wire diagram on fixture.
Step 4
Reinstall the knock out plate.
Step 5
Install troffer into grid.
Step 6
Adjust fixture to sit properly in grid.
Ensure fixture is installed based
on the local codes.
Installing the 1X4, 2X2 or 2X4 Units:
© 2016 Acuity Brands Lighting, Inc. Rev 1/16 065-1163 pg 1 of 2
Technical Services Phone [phone]
1300 South Wolf Road • Des Plaines, IL 60018 USA • Phone [phone] • www.junolightinggroup.com