Technical Specifications

One Lithonia Way, Conyers, GA 30012 | 770-922-9000 | www.lithonia.com
© 2018 Acuity Brands Lighting, Inc. All rights reserved. Rev. 12/19/18 Page 2 of 2
CONTRACTOR SELECT 65BEMW-65SEMW SERIES LED
7 5/8
[19.4]
5 5/8
[14.3]
2 3/4
[7.1]
INTENDED USE:
Our recessed LED module is the most economical means to create a well lit environment
with exceptional energy efciency and near zero maintenance. Great for retrot into existing
downlight cans or new construction and remodel applications. Adjustable torsion spring and
retention etentiondownlight cans or new construction and remodel applications. Adjustable
torsion spring and retention hours. Indoor and outdoor use.
CONSTRUCTION:
65BEMW has an aluminum spun reector with deep bafe conguration for reduced glare.
Combined LED and driver printed circuit board attached. Inner reector cone funnels light
through the pressed-in diffused lens.
OPTICS:
Diffused lens at end of mixing chamber to provide even light distribution for general
illumination, equivalent to 65W BR30 lamp. Wide ood beam angle at >45°.
ELECTRICAL:
Center 2 Edge™ (patent pending) technology created for a single point source. Primary power
disconnect provided for simple connection to a dedicated LED connector in the housing.
Dimming down to 10%. For compatible dimmers, refer to Compatible Dimmers Chart.
835-lumen E series has an input wattage of 11.9 watts, 70 lumens per watt, equivalent to 65-
watt incandescent. E Series’ patent pending driver has zero inrush, which allows power loads
to be calculated with actual rated wattages. Example: 50 units of 65BEMW LED xtures can be
installed in line with a 600-watt dimmer. 600W/11.9W=50 xtures.
INSTALLATION:
Suitable for installation in standard and shallow-height rough-in sections. E26 socket adapter
ships standard. Twin torsion springs ensure easy installation for 5" and 6" recessed housings.
LISTINGS:
CSA certied to US and Canadian safety standards. ENERGY STAR® certied. Can be used
to. comply with California Title 24 Part6 High Efcacy LED Light Source Requirements. Wet
location listed. WSEC ASTM E283 for Air-Tight (with IC housings).
WARRANTY:
5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
Specifications Dimensions
All dimensions are inches (centimeters)
unless otherwise indicated.
Aperture: 5-5/8 (14.3)
Ceiling opening: Determined by rough-in
Overlap trim: 7-5/8 (19.4)
Height: 2-3/4 (7.1)