Installation Guide

Lithonia Downlighting Part No. RD303378 Rev. A

800-315-4935 / www.lithonia.com Page 2 of 15

INSTALLATION INSTRUCTIONS

3” – 3iG iGimbal LED Modules, 4” – 4iG iGimbal LED Modules,

5” – 5iG iGimbal LED Modules, 6” – 6iG iGimbal LED Modules

WARNING: Prior to installing the fixture, disconnect ALL power supplies to the unit. To prevent wiring damage or abrasions, do

not expose wiring to edges of sheet metal or other sharp objects. This module may be installed into TYPE IC or NON-IC

installations. For TYPE NON-IC INSTALLATION ONLY: No insulation may be placed over the top of or within 3” (76mm)

of the fixture.

The downlight module is accepted as a component of a luminaire where the suitability of the combination shall be

determined by CSA or authorities have jurisdiction. The contents of the retrofit kits are:

 LED Module

 Instruction Sheet

 Two Red Splice Connectors

 E26 Adaptor (included with 5iG and 6iG models only)

WARNING: RISK OF FIRE OR ELECTRICAL SHOCK.

Install this kit only in the luminaires that has the construction

features and dimensions shown in the photographs or drawings.

INSTALLATION – 3” AND 4” LED MODULES (Model# 3iG AND 4iG)

Retrofit 3” or 4” Installation with Hardwire Connection Kit:

1. Remove the existing lamp and reflector, leaving the socket hanging freely by the

wires

2. Cut existing socket wires inside the recessed can close to the socket, and discard

the socket.

3. Remove the socket adapter from the box. Cut both adapter wires close to the

socket adapter and away from the orange connector, and discard the socket.

Remove the (2) red splice-connectors from the hardwire kit bag. Pair the housing

and orange connector wires by color into each red connector. Firmly squeeze the

metal U-shaped insert into the wires. Flip the cover closed to secure and insulate

the connection. (See Figure 1)

4. While supporting the LED module, plug connector from the module into the mating connector just installed into the

recessed can. Push the wires and mated connectors up into the recessed can.

DO NOT LET THE MODULE HANG UNSUPPORTED BY THE ORANGE CONNECTORS. (See Figure 3)

5. Once all connections are complete, gently push the LED trim into the recessed can opening until clips engage inside

of can, and the trim is flush with the ceiling surface.

NOTE: If installing into a remodeler-style recessed can with internal ceiling support clips, be sure to

offset the trim clips away from the black clips inside can.

6. INSTALLATION COMPLETE.

Figure 1