Installation Guide

U999350, Rev A, 10/18/2016
BLT LED IMPORTANT SAFETY INSTRUCTIONS
3. Grasp the side of the diffuser where the trim ring has been removed and angle away from fixture and pull
out.
NOTE: The other trim ring can remain installed for any necessary maintenance.
Diffuser Installation
1. To re-install the diffuser after maintenance, slide diffuser into trim ring that remained in the fixture.
2. Place the second trim ring on the end of the diffuser and lever up into assembly.
3. Push trim ring against end cap and align keyholes. Push upwards until you hear a snap. Replace the locking
screw into the end cap.
SAVE THESE INSTRUCTIONS
Keyhole