Manualshelf

Installation Sheet

ManualsBrandsLithonia Lighting ManualsAll Lithonia LightingLithonia Lighting BLT Single Light 23-3/4" Wide Integrated LED Ceiling Troffer - 3500K - Battery Backup
1234
Page 4 of 4
U991740 - Rev A
10/13/15
BLT LED IMPORTANT SAFETY INSTRUCTIONS
Figure 3: Lens Removal and Installation
Figure 4: Cross section of lens installed onto fixture
Diffuser
Cleaning of the outside of the diffuser can be done with a soft cloth and water. The diffuser does not need
to be removed for cleaning.
The diffuser should not require removal during normal operation. However, if maintenance of LED’s is
required, the diffuser is removable.
Lens Removal
1. Grasp one side of the lens at midpoint. Place fingers under the edge closest to the metal reflector.
2. Pull diffuser away from fixture until it comes free. Do not over stress edge under latches by over rotating
diffuser after it unsnaps.
Lens Installation
1. Line up one side edge of the lens under both end latches
2. Rotate the lens to secure. Push on the lens near outer latches until you hear a Click from both ends of the
fixture.
CAUTION: Lens is not fully installed if Click is not heard. Squeeze the lens end near each latch as you push in
to hear the “Click” (see Figure 4).