Installation Guide

page 4
TO MOUNT FIXTURE:
1. Remove fixture components and parts pack(s). Check that
all parts are included._________
___ See Fig 1.
WIRING AND FIXTURE OPERATION
CAUTION: Connect fixture to supply wires rated for at least 90°C
( 194°F ). Do not use fixture on dimming circuits.
Note: Assistance may be required to support fixture during
installation.
2. Thread (1) 1/8IP x 2" Nipple into Crossbar, about ¼".(head of
green screw should face outward).__
_____ See Fig 2.
3. Attach the crossbar to the junction box by inserting the (2) #8-
32 x 1" machine screws through the slots in the crossbar into the
junction box. (head of green screw should face out-
ward).___________________________________ See Fig 2.
4.With the power turned off, connect the copper ground wire
from the fixture to the bare copper ground wire from the junction
box, by wrapping them under the head of the green ground
screw and securing them to the crossbar. (If house wiring does
not include a ground wire, consult your local electrical code for
approved grounding methods).
5. Use wirenuts to connect black fixture wire to the black power
supply wire(s)and the white (neutral) fixture wire to the white
power supply wire(s).
FOR PROPER CONNECTION, PLACE WIRENUT OVER
WIRES, TWIST CLOCKWISE UNTIL TIGHT.
6. Position the Canopy over the nipple protruding from the cross-
bar and install the Ball Finial to secure the Canopy against the
wall. ____________________________________See Fig. 1.
7. Unscrew the Ballast Lock Ring from the Ballast Socket.
_________________________________________See Fig. 1.
8. Place the Glass Shade over the Ballast Socket and reinstall
the Ballast Lock Ring. Adjust shade and tighten
ring._____________________________________See Fig. 1.
9. Insert the lamp.___________________________See Fig. 1.
10. Turn on electricity at fuse or circuit breaker box .
11. To replace the Ballast: Turn off electricity at fuse or circuit
breaker box. Unscrew the Ballast Lock Ring and remove the
Glass Shade. Firmly grasp the shade cup and rotate the Ballast
Socket counter clock-wise. Obtain replacement ballast and re-
install in reverse order.
Figure 2