Installation Guide

ASSEMBLY INSTRUCTIONS
5
Remove decorative nuts (E) from front of fixture
(A) and remove mounting plate (B) from back of
fixture (A).
Save decorative nuts (E) for later use.
3.
Attach mounting plate (B) to outlet box (not
included) using existing washers and outlet box
screws or the machine screws (BB). NOTE: If the
outlet box screws required for your outlet box are
of a different size than the machine screws (BB),
consult a licensed electrician before proceeding.
Tighten machine screws (BB) to secure mounting
plate (B).
CAUTION: Make sure the outlet box can
support 35 lbs. hanging weight. Use metal outlet
box; plastic outlet boxes are not recommended.
4.
Hardware Used
Machine Screw
x 2
BB
4
Outlet Box
BB
BB
Washer
Washer
5
Outlet Box
A
D
C
E
B
Adjust screws (C) to proper length by screwing
them completely into mounting plate (B).
Temporarily place fixture (A) over mounting plate
(B) to determine amount of adjustment necessary
for screws (C). NOTE: Screws (C) should come
through holes in fixture (A) just enough so
decorative nuts (E) fit flush against fixture (A)
when mounted.
Once screws (C) are adjusted, tighten nuts (D)
securely against mounting plate (B).
5.
3
A
E
B
E
B