Installation Guide

page 7
9. Light Kit Assembly (Optional). (cont.)
Locate BLACK (or BLUE) and WHITE wires in
switch housing labeled "LIGHT." Remove and
discard plastic that holds these 2 wires
together.
Remove hex nut and lock washer from
threaded rod at top of light kit fitter. Punch
center cap out of switch housing cap with a
screwdriver. Feed wires (one by one) from light
kit fitter through center hole in switch housing
cap. Then, screw switch housing cap onto
threaded rod on light kit fitter followed by lock
washer and hex nut. Tighten hex nut over lock
washer for a secure fit.
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLACK (or
BLUE) wire from switch housing. Be sure
molex connections snap together completely.
Carefully arrange wiring within switch housing
and then align holes in switch housing cap
with holes in switch housing. (Note: Make sure
to align gap on top edge of the switch
housing cap with the reverse switch on switch
housing for the correct fit.) Re-insert 3 screws
that were previously removed and use a
Phillips screwdriver to secure all screws.
Install 2 medium base 6.5 watt LED bulbs
(included).
IMPORTANT: When you need to replace bulbs,
please allow bulbs and glass shade to cool
down before touching them.
Thread pull chains for fan and light through
corresponding pull chain guides on the outer
rim of the light kit fitter.
Align grooves on glass shade with nodules on
inside of light kit fitter and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
switch
housing
molex
connections
white
white
light kit fitter
light kit fitter
threaded rod
threaded rod
switch housing
cap
switch housing cap
center cap
hex nut
lock washer
motor housing
hex nut
lock washer
motor housing
switch housing
cap
bulb
switch
housing
black
(or blue)
black
reverse switch
glass
shade
groove
pull chain
guide
pull chain
motor
housing