Installation Guide

5
ASSEMBLY INSTRUCTIONS
Remove decorative nuts (E) from front of fixture
(A) and remove mounting plate (B) from back of
fixture (A).
Save decorative nuts (E) for later use.
3.
4.
Hardware Used
Machine Screw
x 2
BB
4
Attach mounting plate (B) to outlet box
(not included) using existing washers and
outlet box screws or the machine screws (BB).
NOTE: If the outlet box screws required for
your outlet box are of a different size than the
machine screws (BB), consult a licensed
electrician before proceeding.
Tighten machine screws (BB) to secure
mounting plate (B).
CAUTION: Make sure the outlet box can
support 35 lbs. hanging weight. Use metal
outlet box; plastic outlet boxes are not
recommended.
Outlet Box
B
BB
BB
3
E
E
A
B
Adjust screws (C) to proper length by screwing
them completely into mounting plate (B).
Temporarily place fixture (A) over mounting plate
(B) to determine amount of adjustment necessary
for screws (C). NOTE: Screws (C) should come
through holes in fixture (A) just enough so
decorative nuts (E) fit flush against fixture (A)
when mounted.
Once screws (C) are adjusted, tighten nuts (D)
securely against mounting plate (B).
5.
5
Outlet Box
A
D
C
E
B