Installation Guide

ASSEMBLY INSTRUCTIONS

Wrap electrical tape (not included) around each

individual wire connector (AA) down to the wire.

Push wire connectors (AA) gently back into outlet

box. Carefully push excess wiring into outlet box.

WARNING: Make sure no bare wire or wire

strands are visible after making connections.

Outlet

Box

Outlet

Box

WHITE

GREEN/

BARE

BLACK

x 3

Hardware Used

Wire Connector

Unwrap BARE fixture wire from BLACK and WHITE

fixture wires. Prepare wires by stripping 3/4 in. of

insulation from wire ends using wire strippers (not

included).

Connect WHITE wire from fixture (A) to WHITE wire

from outlet box using existing wire connector or wire

connector (AA). Connect BLACK wire from fixture (A)

to BLACK wire from outlet box using existing wire

connector or wire connector (AA). Connect

BARE/GREEN ground wire from outlet box to BARE

ground wire from fixture (A) with wire connector (AA).

NOTE: Screw wire connectors (AA) on in a

clockwise direction.

WARNING: Never connect ground wire to

WHITE or BLACK power supply wires.

WARNING: To reduce the risk of fire, electrical

shock or personal injury, wire connectors (AA) are

designed to accept only one 12-gauge house wire

and two lead wires from the light fixture. If your

house wire is larger than 12-gauge or there is more

than one house wire to connect to the corresponding

fixture lead wires, consult an electrician for the

proper size wire connectors to use.