Installation Guide

ASSEMBLY INSTRUCTIONS
5
4.
Outlet
Box
Feed wires through center on mounting plate
(B). Attach mounting plate (B) to outlet box
(not included) using existing washers and
outlet box screws or the machine screws (BB).
NOTE: If the outlet box screws required for
your outlet box are of a different size than the
machine screws (BB), consult a licensed
electrician before proceeding.
Adjust mounting plate (B) so fixture screws
(CC) on mounting plate (B) are perpendicular
to floor and ceiling. Then, tighten machine
screws (BB) completely to secure mounting
plate (B).
CAUTION: Make sure the outlet box can
support 35 lbs. hanging weight. Use metal
outlet box; plastic outlet boxes are not
recommended.
Hardware Used
Machine Screw
x 2
BB
Washer
Washer
3A.
DD
3A
B
Remove decorative nuts (DD) and nuts (EE)
from fixture screws (CC). Save decorative nuts
(DD) and nuts (EE) for later use.
Insert fixture screws (CC) into holes in the
mounting plate (B), one across from the other,
as shown. Insert fixture screw (CC) heads from
the opposite side of the mounting plate (B) as
the GREEN ground screw head.
Hardware Used
Fixture Screw
x 2
CC
EE
CC
GREEN
Ground Screw
(Head)
Decorative Nut
x 2
DD
Nut
x 2
EE
3B
3B.
Fixture Screw
x 2
CC
CC
CC
B
4
BB
BB
CC