Installation Guide

page 5
7. Fan Assembly.
Remove motor assembly from temporary
hanging slot in hanging bracket. Carefully
push wiring and wire connectors into
outlet box. Slide one end of bar on motor
assembly through one of the openings in
the hanging bracket. Lift the other end of
the motor assembly and slide it through
opposite opening on hanging bracket.
Align holes in top of motor assembly with
holes in hanging bracket. Secure motor
assembly to hanging bracket with lock
washers and motor mounting screws that
were previously removed (Section 5).
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to in the instructions below, please use
a qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wire from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires from fan
together to BARE/GREEN wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from fan
to the BLACK supply from the independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
motor
mounting
screws and
lock washers
motor
mounting
screws and
lock washers
hanging
bracket
opening
6. Wiring.
hanging
bracket
opening
slot
motor assembly
hanging
bracket
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GROUND (GREEN OR BARE)
GREEN
GREEN