Installation Guide

page 4
hanging
bracket
hanging
bracket slot
Remove 4 motor mounting screws and
lock washers from the bar on the top of
motor assembly; leave rubber cushions in
place. Lift motor assembly to hanging
bracket and place one end of motor
assembly in hanging bracket slot. This
will allow motor assembly to hang out of
the way while wiring.
Tip: Seek the help of another person to
hold the stepladder in place and to lift
the fan up to you once you are set on the
ladder.
motor assembly
motor
mounting
screws and
lock washer
5. Preparation for Wiring.
NOTE: The important safety precautions
and instructions appearing in the manual
are not meant to cover all possible
conditions and situations that may occur.
It must be understood that common sense
and caution are necessary factors in the
installation and operation of this fan.
Find a secure attachment point (wood
ceiling joist highly recommended) and
secure safety cable. It will be necessary to
use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety
cable loop. Extra cable slack can be left in
ceiling area.
Adjust safety cable length by loosening
screw and nut on the safety cable vice
and pulling on the cable. Adjust slack in
cable to a hands length and secure vice
by tightening screw and nut securely. The
loop at the end of the safety cable should
just fit over the threads on the wood
screw. Test safety cable by pulling on loose
end of cable with pliers. If the safety cable
slips, the screw and nut on the vice must be
set tighter.
safety cable loop
safety
cable
wood screw
and washer
nut
screw
wood joist
motor assembly
safety
cable