Installation Guide

OPERATING INSTRUCTIONS FOR REMOTE CONTROL AND FAN

Modifications not approved by the party responsible for compliance could void the user's authority to

operate the equipment.

*NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

The tilt angle of the smaller fans may be adjusted up or

down by simply manually moving them gently up or

down.

CAUTION: To avoid personal injury or damage to

the fan(s), both the main fan and the smaller fans

MUST BE OFF before adjusting the smaller fans up

or down.

smaller fan smaller fan

main fan

Operation buttons on the panel of the remote control

transmitter (I) :

Button turns the 2 smaller fans to HIGH

speed

Button turns the 2 smaller fans to MEDIUM

speed

Button turns the 2 smaller fans to LOW

speed

Button turns the 2 smaller fans OFF

Button turns main fan ON/OFF when pressed

once (i.e., controls rotation of the entire

fan)

Button turns light ON/OFF when pressed

once; If you press button in excess of

0.7 seconds, it becomes a dimmer.