Installation Guide

page 9
11. Testing Your Fan.
diagram 1
diagram 2 diagram 3 diagram 4
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on switch housing. Start at the OFF position (no
blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull will
set the fan to LOW. Fourth pull will re-set the fan to
OFF setting. Test light with pull chain in the middle.
(diagram 1) If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
reverse switch
pull chains