Installation Guide

page 8
10. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on switch housing. Start at the OFF position
(no blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will re-set the fan
to OFF setting. Test light with pull chain in the
middle. (diagram 1) If fan and/or light do (does) not
function, please refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
9. Light Kit Assembly. (cont.)
Remove finial, finial plate and threaded washer from
light kit fitter.
Raise glass shade in order to guide pull chains
through corresponding holes at the bottom of the
glass shade. Align threaded rod on light kit fitter with
hole in middle of glass shade and push up gently
allowing threaded rod to come through hole. (Be
sure pull chain for fan operation does not rub
against bulb during operation.) Secure glass shade
to light kit fitter with threaded washer.
Note: Do not overtighten threaded washer as glass
may crack or break.
Align threaded rod with center hole in finial plate,
allowing pull chains to come through corresponding
holes in finial plate, and push up. Thread center pull
chain through hole in finial and tighten.
Note: Do not overtighten finial as glass may crack or
break.
diagram 2 diagram 3 diagram 4
diagram 1
glass shade
pull chains
finial plate
pull chains
finial
threaded washer
motor
housing