Installation Guide

8. Blade Assembly.

page 6

7. Canopy Assembly.

canopy

hanging bracket

screw

Locate 2 screws on underside of hanging bracket

and remove screw closest to the open end of the

hanging bracket. Partially loosen the other screw.

Lift canopy to hanging bracket. Place rounded part

of slotted hole in canopy over loosened screw in

hanging bracket and push up. Twist canopy to lock.

Re-insert screw that was removed and then tighten

both screws securely. Slide canopy cover up to

canopy, aligning rounded part of slotted holes in

canopy cover with screwheads in bottom of

canopy. Turn canopy cover to the right (clockwise)

until it stops.

canopy cover

blade

Time Saver: Washers for blade screws can

be set on each blade screw prior to

installing blades.

Locate 15 blade attachment screws and

washers in hardware pack. Slide blade

through one of the narrow, rectangular

openings on motor housing, aligning

holes in blade with holes in blade plate

(located on the underside of the motor

housing)--refer to drawing at right. Insert 3

blade attachment screws (along with

washers) with fingers first and then

tighten screws securely with a Phillips

screwdriver. Repeat procedure for each

remaining blade.

Note: Tighten blade arm screws twice a

year.

rectangular

opening

motor housing

rectangular

opening