Installation Guide

page 6
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely. Slide canopy cover up to
canopy, aligning rounded part of slotted holes in
canopy cover with screwheads in bottom of
canopy. Turn canopy cover to the right (clockwise)
until it stops.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. Align blade arm
holes with motor screw holes and attach one
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
motor
housing
blade arm
blade
blade arm screws
lock washers
blade attachment
screws and washers
canopy
hanging bracket
screw
screw
canopy cover