Installation Guide

5. Fan Assembly.
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
page 4
set screw hole
set screw
hanging ball
stop pin
A
B
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4.5in. downrod provided to use with
an extended downrod (sold separately). [If you
wish to use the 4.5in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Loosen yoke set screws and nuts and remove
pin and clip at top of motor housing. Slide
downrod through canopy, canopy cover and
yoke cover. [Note: Canopy cover must be
turned with the non-slotted side toward the
motor housing.]
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke
and re-insert pin and clip that were just
removed. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
canopy cover
yoke cover
motor
housing
yoke set screw
downrod
electrical wiring
clip
pin
canopy