Installation Guide

page 7
9. Light Kit Assembly (Optional).
motor housing
Remove 3 screws from top of light kit fitter.
If you wish to use your fan WITH the light kit,
remove finial, finial plate, threaded washer and
rubber washer from bottom of light kit fitter.
Save finial, finial plate, threaded washer and
rubber washer for later use.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT. Remove and
discard plastic that hold these 2 wires together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Make sure that molex
connections are secure.
To attach light kit fitter to motor assembly, align
holes in switch housing cap with holes in switch
housing. (NOTE: Make sure to align gap on top
edge of the switch housing cap with the reverse
switch on switch housing for the correct fit.)
Re-insert 3 screws that were removed above and
use a Phillips screwdriver to secure all screws.
Install 3 candelabra base 40-watt max. bulbs
(sold separately).
Important: When you need to replace bulbs,
please allow bulbs and glass shade to cool down
before touching them.
Proceed to following page to complete installation
WITH light kit. For use of fan WITHOUT light kit,
please proceed to page 9.
motor housing
switch
housing
molex connections
light kit fitter
switch housing
cap
reverse
switch
finial plate
threaded
washer
finial
rubber
washer
switch
housing
motor
housing
light
kit fitter
switch
housing
screw
bulb