Installation Guide

7. Motor Housing Assembly.
page 6
8. Blade Assembly.
Locate 4 small metal posts on the outside edge
of the hanging bracket. Now, locate the 4
metal bars on the inside of the motor housing.
Raise motor housing to hanging bracket and
align the 4 metal posts on the hanging bracket
with the 4 metal bars on the motor housing.
Turn motor housing clockwise, to the RIGHT,
until it no longer turns so that it locks.
Note: It is extremely important that you make
sure that you turn the motor housing all the
way to the right to ensure that the motor
housing is completely secure.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers
from fan motor and set aside. Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws completely, repeat
procedure with remaining blade arms. Secure
all screws.
Note: Tighten blade arm screws twice a year.
hanging
bracket
metal
bars
metal
bars
metal posts
J
motor
housing
blade
lock washers
blade arm screws
blade attachment
screws and washers
blade arm
motor housing