Installation Guide

page 10
10. Testing Your Fan.
diagram 2
diagram 3
diagram 4
pg
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain on switch housing.
Start at the OFF position (no blade movement).
First pull will set the fan to HI. Second pull will
set the fan to MEDIUM. Third pull will set the fan
to LOW. Fourth pull will again set the fan to OFF
setting. If applicable, test light with pull chain in
the middle (diagram 1). If fan and/or light
do/does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or
custom pull chain extension(s) (sold separately)
to end(s) of the pull chain(s).
diagram 1
light pull chain
extension
fan pull
chain extension
glass shade
motor housing
reverse
switch