Installation Guide

9. Light Kit Assembly (Optional). (cont).
Locate cap in one of the hardware packs and
place cap firmly in hole in middle of switch
housing cap. Align holes in switch housing cap
with holes in switch housing, making sure to
align gap in top edge of switch housing cap with
reverse switch in switch housing for the correct
fit. Secure switch housing cap with 3 screws that
were removed at the beginning of Section 9,
"Light Kit Assembly (Optional)", (page 7). Tighten
all 3 screws securely.
page 9
If you wish to use your fan WITHOUT the light
kit, remove the hex nut and lock washer from
the threaded rod at the top of the light kit fitter.
Unscrew the switch housing cap to remove it
from the light kit fitter, and then gently feed
the BLACK and WHITE wires from the light kit
fitter (one at a time) through the hole in the
middle of the switch housing cap.
switch housing
screw
switch
housing
cap
cap
motor housing
switch
housing
P
switch
housing
cap
light kit
fitter
WHITE
BLACK
P
hex nut
lock washer