Installation Guide

6
ASSEMBLY INSTRUCTIONS
5.
Wrap electrical tape (not included) around each
individual wire connector (AA) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections.
Carefully arrange excess wiring and wire
connectors (AA) within outlet box.
Outlet Box
AA
AA
5
6.
Align keyhole slots on fixture (A) with fixture
screws (D) on mounting strap (C) and push up.
Turn fixture (A) clockwise until it no longer turns.
Secure fixture (A) to mounting strap (C) by
tightening the fixture screws (D).
6
A
Outlet Box
D
C
Remove finial (I), nut (H), flat washer (G) and
rubber washer (F) from threaded rod (E)—refer
to drawing at right. Save all for later use.
Attach threaded rod (E) to fixture (A) and tighten
threaded rod (E) with pliers (not included).
[NOTE: Hold pliers just under nut (H) at top of
threaded rod (E) so as not to strip threads on
threaded rod (E).] Once threaded rod (E) is
completely tightened, use pliers to secure nut (H)
at top of threaded rod (E) to bottom of fixture (A).
7.
I
7
A
E
F
G
(DO NOT
remove)
H
AA
D
H