Installation Guide

8
ASSEMBLY INSTRUCTIONS
Wrap electrical tape (not included) around each
individual wire connector (AA) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections.
Carefully arrange excess wiring and wire
connectors (AA) within outlet box.
13
13.
AA
AA
AA
12.
Connect SMOOTH wire from fixture (A) to BLACK
wire from outlet box using wire connector (AA).
Connect RIBBED wire from fixture (A) to WHITE
wire from outlet box using wire connector (AA).
Connect BARE/GREEN wire from outlet box to
BARE ground wire from fixture (A) using wire
connector (AA).
NOTE: If outlet box does not have a BARE/GREEN
wire, the BARE ground wire from fixture (A) should
be attached to the GREEN GROUND SCREW
(labeled GND) on mounting strap (C).
Hardware Used
Wire Connector
x 3
AA
Feed wiring up through hole at bottom of threaded
rod (D). Gently push wiring until it comes through
top of threaded rod (D). Pull all wiring until there is
no extra slack left in the wires running through the
chain (H).
Prepare wires from outlet box by stripping 3/4 in. of
insulation from wire ends using wire strippers (not
included).
11.
BLACK
SMOOTH
Wire
WHITE
RIBBED
Wire
12
Outlet Box
BARE
BARE/
GREEN
Threaded
Rod
AA
H
AA
AA
GREEN
Ground Screw
C
Wiring
11
D
H
Outlet
Box
Outlet Box