Installation Guide

ASSEMBLY INSTRUCTIONS

Attach mounting strap (C) to outlet box (not

included) using existing washers and outlet box

screws or the machine screws (BB). NOTE: If the

outlet box screws required for your outlet box are

of a different size than the machine screws (BB),

consult a licensed electrician before proceeding.

CAUTION: Make sure the outlet box can

support 35 lbs. hanging weight. Use metal outlet

box; plastic outlet boxes are not recommended.

Washers

Outlet Box

Slide column (I) down wiring to top of fixture (A).

Attach column (I) to threaded rod on fixture (A) by

turning column (I) clockwise until it no longer

turns.

Remove threaded ring (E) from screw collar loop

(F) and save for later use.

Temporarily place canopy (B) over mounting

strap (C) to determine amount of adjustment

necessary for threaded rod (D). NOTE: Canopy

(B) should fit flush against ceiling when mounted.

Once threaded rod (D) is adjusted, tighten hex nut

(G) securely against mounting strap (C).

Set canopy (B) aside.

Hardware Used

Machine Screw

x 2

Threaded

Rod