Installation Guide

page 6
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 12 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws premanently,
repeat procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Blade Assembly.
blade arm
blade
motor housing
blade attachment
screws and washers
blade arm screws
lock washers
plastic
motor lock
10. Light Assembly.
Install 1 medium base 6.5 watt LED bulb
(included).
Important: When replacing bulb, please allow
bulb and glass shade to cool down before
touching them.
Partially loosen 3 thumbscrews in light kit plate.
["Light Assembly" continued on next page.]
bulb
thumbscrew
light kit plate
thumb-
screw